
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
℃
CONSTANT CURRENT REGION
Note.4
HLG-320H-12 A
A : IP65 rated. Output voltage and constant current level can be adjusted through internal potentiometer.
B : IP67 rated. Constant current level adjustable through output cable with 1~10Vdc or PWM signal or resistance.
C : Terminal block for I/O connection. Output voltage and constant current level can be adjusted through internal
D (option) : IP67 rated. Timer dimming function, contact MEAN WELL for details.
potentiometer.
SPECIFICATION
MODEL
DC VOLTAGE
RATED CURRENT
RATED POWER
OUTPUT
VOLTAGE ADJ. RANGE Note.6
CURRENT ADJ. RANGE
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME Note.8
HOLD UP TIME (Typ.)
VOLTAGE RANGE Note.5
FREQUENCY RANGE
POWER FACTOR (Typ.)
EFFICIENCY (Typ.) (230Vac)
EFFICIENCY (Typ.) (277Vac)
AC CURRENT (Typ.)
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS Note.7
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
PACKING
OVER CURRENT Note.4
OVER VOLTAGE
OVER TEMPERATURE
Can be adjusted by internal potentiometer A type and C type only
2500ms,80ms/115VAC 500ms,80ms/230VAC at full load
15ms at full load 230VAC /115VAC
90 ~ 305VAC 127 ~ 431VDC
47 ~ 63Hz
PF>0.98/115VAC, PF>0.95/230VAC, PF>0.94/277VAC at full load (Please refer to "Power Factor Characteristic" curve)
3.5A / 115VAC 1.65A / 230VAC 1.45A / 277VAC
<0.75mA / 277VAC
95 ~ 108%
Protection type : Constant current limiting, recovers automatically after fault condition is removed
Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C ( 50% load) ; EN61000-3-3≧
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria B
-40 ~ +70 (Refer to "Derating Curve")℃
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH
℃
±℃ ℃
0.03%/ (0 ~ 50 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
J61347-2-13 approved(except for HLG-320H C type)
UL8750, EN61347-1, EN61347-2-13 independent (except for HLG-320H C type)CSA C22.2 No. 250.0-08, , J61347-1,
IP65 or IP67 ,
157.1K hrs min. MIL-HDBK-217F (25 )℃
252*90*43.8mm (L*W*H)
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Please refer to "DRIVING METHODS OF LED MODULE".
5. Derating may be needed under low input voltages. Please check the for more details.static characteristics
6. A type and C type only.
7. Safety and EMC design refer to EN60598-1, subject CNS15233, GB7000.1, FCC part18.
8. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
9. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
10. Refer to warranty statement.
11. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently
connected to the mains.
1.88Kg; 8pcs/16Kg/0.92CUFT
Protection type : Shut down and latch off o/p voltage, re-power on to recover
Shut down and latch off o/p voltage, re-power on to recover
320W Single Output Switching Power Supply
Universal AC input / Full range (up to 305VAC)
Built-in active PFC function
High efficiency up to 95%
Protections: Short circuit / Over current / Over voltage / Over temperature
Cooling by free air convection
OCP point adjustable through output cable or internal potentiometer
IP67 / IP65 design for indoor or outdoor installations
Type HL LED Driver for use in Class , Division 2 hazardous location luminairesⅠ
Three in one dimming function (1~10Vdc or PWM signal or resistance)
Suitable for LED lighting and street lighting applications
Compliance to worldwide safety regulations for lighting
Suitable for dry / damp / wet location
5 years warranty (Note.10)
■ Features :
HLG-320H series
RIPPLE & NOISE (max.)
Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
PROTECTION
FMM
110
SELV
IP65 IP67
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed
Blank : IP67 rated. Cable for I/O connection.
14 ~ 17V 17.5 ~ 21V 22.5 ~ 27V 27 ~ 33V 33 ~ 37V 40 ~ 46V 53.5 ~ 60V
46.5 ~ 53V 59 ~ 65V
91%
91.5%
92.5%
93%
93.5%
94%
94%
94.5%
94%
94.5%
94.5%
95%
95%
95%
95%
95%
95%
95%
±3.0%
11 ~ 22A
±2.0%
9.5 ~ 19A
±1.5%
7.5 ~ 15A
±1.0%
6.67 ~ 13.34A
±1.0%
5.35 ~ 10.7A
±1.0%
4.45 ~ 8.9A
±1.0%
3.35 ~ 6.7A
±0.5% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5%
±2.0% ±1.5% ±1.0% ±0.5% ±0.5% ±0.5% ±0.5%
±1.0%
2.97 ~ 5.95A
±0.5%
±0.5%
±1.0%
3.8 ~ 7.65A
±0.5%
±0.5%
HLG-320H-12
HLG-320H-15
HLG-320H-20
HLG-320H-24
HLG-320H-30
HLG-320H-36
HLG-320H-48
12V
6 ~12V
15V
7.5 ~ 15V
20V
10 ~ 20V
24V
12 ~ 24V
30V
15 ~ 30V
36V
18 ~ 36V
48V
24 ~ 48V
22A 19A 15A 13.34A 10.7A 8.9A 6.7A
264W 285W 300W 320.16W 321W 320.4W 321.6W
150mVp-p 150mVp-p
13.5 ~ 17V
150mVp-p
17 ~ 22V
150mVp-p
21 ~ 26V
200mVp-p
26 ~ 32V
250mVp-p
32 ~ 39V
250mVp-p
43 ~ 52V10.8 ~ 13.5V
HLG-320H-54
54V
27 ~ 54V
5.95A
321.3W
350mVp-p
49 ~ 58V
HLG-320H-42
42V
21 ~ 42V
7.65A
321.3W
250mVp-p
38 ~ 45V
EMC IMMUNITY
EMC EMISSION
COLD START 70A(t =1010 s measured at 50% I ) at 230VACwidth peak
μ
THD< 20% when output loading 50% at 115VAC/230VAC input and output loading 75% at 277VAC input≧≧
TOTAL HARMONIC DISTORTION
MAX. No. of PSUs on 16A
CIRCUIT BREAKER 1 unit (circuit breaker of type B) / 2 units (circuit breaker of type C) at 230VAC
Bauar
Sicherheit
egel gema
t gepruft
od
be
www.
ID 2000000000
tuv.com
wac g
os
File Name:HLG-320H-SPEC 2015-05-11
NOTE