OSHW
Follow Us
Product Forum Arduino MBED About
W5500 Ethernet Shield Home W5500 Ethernet Shield
W5500 Ehternet Shield
ARM mbed compatible operation
Arduino Pin-compatible
Ethernet (W5500 Hardwired TCP/IP chip)
W5500 Ethernet shield is designed using the WIZnet W5500 chip. Please click the link
for the further information about W5500. It supports both 3.3V & 5V. This Ethernet
Shield is compatible with Arduino and ARM mbed Platform.
RJ-45 with Transformer : Ethernet Port
W5500 : a hardwired TCP/IP Ethernet Controller
RESET : Reset Ethernet shield and Arduino when pressed
SD-Slot : support Micro SD card in FAT16 or FAT32 ; (Please Read the Caution)
I2C : I2C interface
UART : UART interface
Overview
Features
Suppport 3.3V / 5V
High Speed Ethernet controller W5500 chip
SPI interface
Internal 32Kbytes Tx/Rx buffer
10/100 Ethernet PHY embedded
Support Auto Negotiation (Full / Half duplex, 10 / 100-based)
Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
User Selectable GPIO pin
Support SD-card slot for storage
Support I2C, UART interface
Hardware Configuration
User’s Manual
User’s Manual
WIZnet WiKi
WIZnet WiKi
WIZnet e-shop (US)
WIZnet e-shop (US)
WIZnet e-shop (KR)
WIZnet e-shop (KR)
WIZnet e-shop (EU)
WIZnet e-shop (EU)
WIZnet e-shop Hong Kong
WIZnet e-shop Hong Kong
Guide Docs
Technical Support
Buy Now
1. ARM mbed Board
ARM mbed Platform : ARM mbed platform Site
FRDM-KL25Z : Freescale
NXP LPC800-MAX : NXP
Available Board List
OSHW (Open Source Hardware)
>W5500 Ethernet Shield
>ioShield-A
>ioShield-K
>ioShield-L
>WizFi Shield
>W5200 Ethernet Shield