HOW TOUSE THE MULTI-CONNECTOR
1 REMOVING
Loosen clamp ring ❶, and separate the multi-connector into two parts,
socket side and plug side
2 INSERTION AND REMOVAL OF TUBE
1 Turn the clamp bolt ❻to the left with a screw-driver, loosen until the
stopper ❷touches the case ❸, and barb cassette ❹will be pulled out in the
direction A, then clamp portion B, consisting of barb ❺and case ❸, will be
freed. Then insert or remove the tube.
2 The same number curved on every port indicates that socket and plug side
can be connected.
3 If it is hard to insert the tube, enlarge the multi-connector with the head
of stopper, expander C, before inserting tube, to such an extent that it
accommodates the number of tubes you intend to use.
4 Insert tube until it clears the mountain of barb ❺completely.
3 CLAMPING OF TUBE
1 After inserting tube, tighten clamp bolt ❻with a screw driver.
2 Barb cassette creeps into the direction D and the tube will be clamped at
the clamp portion B consisting of barb ❺and case ❸
4 CONNECTING
1 Push together and rotate both of the cases, and the plug side will slide
into the socket side at the proper position.
2 The ring E, male and female, of the plug side and socket side will
interlock each other at the proper position by pushing together and
rotating.
3 Final process of connection is to screw in the clamp ring.
5 COVER MOUNTING
1 Cover is mountable on both sides, plug side and socket side.
2 Enlarge cover and mount cover onto mounting area.
PRECAUTIONS
Be sure to insert the tube slowly so that you feel it
move smoothly and can feel it touch the end.
In case the number of tubes to be used is 6 (DM6)
and 12 (DM12) or less, the positioning of the tube
should be symmetrical to the centre.
0nce the tube has been properly inserted, pull it
back gently, and if it does not come out, it is the
sign of complete insertion.